Technical Information

Nature : Single component.
Appearance : Emulsion (Available in White & Dark bases)
Specific Gravity : 1.29
Coverage : 35 sq.ft/lt. for 2 coats
Coating Thickness : 110 microns DFT for 2 coats
Elongation (250 micron DFT) : >200% (Typical Value at 30°C)
Re-coating period : Min. 5 hrs (at 30°C)
Method of application : By brush, roller or spray
Adhesion on
Cementitious substrate - Excellent
Asbestos - Excellent

PACKING

Area Of Application:

• Exterior surfaces of RCC, concrete panels, plastered masonry walls.

Method of Application

SURFACE PREPARATION

• Surface for treatment must be thoroughly cleaned of all laitance, loose material, oil, grease etc
• Mechanical means such as wire brushing, shot blasting can be used, and finally vacuum clean all loose solids
  and liquids if required.
• All surface cracks up to 5 mm width should be filled up with DR. FIXIT CRACK-X range products.
• The cracks more than 5 mm wide and all separation gaps should be filled up with DR. FIXIT PIDICRETE URP modified mortar or as specified.

APPLICATION PROCEDURE

For External Surfaces: --

• The surfaces should be primed with DR. FIXIT PRIMESEAL diluted with potable water in the ratio of 2:1 by volume prior to application of DR. FIXIT RAINCOAT finish coats and allow it to dry for at least 2 to 3 hrs.
• Apply 2 neat coats of DR. FIXIT RAINCOAT with an interval of 5 to 6 hrs
• Allow it to cure for 7 days

Application of Dr. Fixit Primeseal	Primed Exterior Surface	Application of Dr. Fixit Raincoat