Technical Information
Appearance
|
: |
White |
| Full curing time |
: |
7 days at 30oC |
| Specific gravity |
: |
1.40 ± 0.02 gm/cc |
| Coverage |
: |
25-30 running meter/kg (for a length of 1 metre, and depth and width of 5 mm) |
Packing :
200 g, 500 g, 1 kg & 5 kg
Areas of Application
- Internal & external Plastered brick masonry wall cracks of upto 5mm width
Method of Application
- Surface must be free from dust, oil, grease, and loose particles etc. Moisten the surface before applying
Dr. Fixit Crack-X Paste.
- Fine hair line cracks must be widened up to 1 mm minimum and then filled
- For filling Dr. Fixit Crack-X Paste on the internal surface, existing POP or painter's putty must be removed till
plaster surface is exposed.
- For porous surfaces, apply primer coat prepared with Dr. Fixit Crack-X Paste and water in 1:1 proportion over
the crack. Fill Dr. Fixit Crack-X Paste when the surface is tacky and not dried completely.
- Press Dr. Fixit Crack-X Paste firmly into the crack with a spatula or putty knifes and level with the surface
- Care must be taken to avoid formation of cavities or bubbles during application.
- Allow it set for 24 hours and then apply another coat of Dr. Fixit Crack-X Paste
- Further POP or painter's putty application can be taken up once it is fully dry
- For best results allow Dr. Fixit Crack-X Paste to cure for 7 days.
Precautions & Limitations
- Should not be used for cracks more than 5 mm thick
- Not for application in cracks in structural members, expansion joints & separation gaps.
- Not for cracks in POP or painter's putty
- For application below 10oC, drying time will be delayed
- Container to be tightly closed after application
- Clean tools and hands with soap and warm water
|
 Download |
|
