Technical Information
Mixed pot life
|
: |
2 hours at 30oC (for 1 Ltr mix) |
| Specific gravity |
: |
2.10 + 0.1 |
| Thickness of application |
: |
75 microns w.f.t. |
| Fully re-coatable |
: |
1 hour at 30oC |
Packing 1 litre
Areas of Application
- For coating re-bars and steel surfaces
Method of Application
- Expose fully any corroded steel in the repair area and remove all loose scale and corrosion deposits. Care should be taken
to clean the back of exposed steel bars. Grit blasting is recommended for this purpose.
- The application of Dr. Fixit Epoxy Zinc Primer must take place as soon as possible to a dry steel surface after completion of
the preparation work but always within three hours.
- Apply one full coat of Dr. Fixit Epoxy Zinc Primer by a suitable brush, making sure that the back of exposed steel reinforcement
bars are properly coated.
- Apply second coat, in case of any discontinuity in the first coat, after drying of first coat.
- The primed surface should not be left exposed to a longer time. The application of concrete repair material should proceed
as soon as the Dr. Fixit Epoxy Zinc Primer is fully dry.
Precautions & Limitations
- Dr. Fixit Epoxy Zinc Primer should not be applied when the temperature is below 10oC or is above 40oC
- Epoxy Zinc Primer is flammable.
- Keep away from source of ignition
- Flash point : 16oC
- In case of fire extinguish with CO2 or foam
|
 Download |
|
