Technical Information
Pot life
|
: |
45 minutes at 30oC (For 10 kg of mixed material ) |
| Foot traffic |
: |
24 hrs after application |
| Full Cure & Chemical resistance |
: |
7 days |
| Compressive strength |
: |
50 N/mm2 at 7 days |
| Flexural strength |
: |
18 N /mm2 at 7 days |
| Tensile Strength |
: |
8 N / mm2 at 7 days |
| Coverage |
: |
1.5 m2 per 10 kg pack at 3 mm (1.0 m per 10 kg pack at 5 mm) |
| Shelf life |
: |
12 months in an unopened pack if stored properly below 30oC |
Packing 10 kg
Areas of Application
- For repair in chemical industry, heavy industry, ramps, loading and unloading bays, paint shops, battery rooms, food processing plants etc.
Method of Application
Surface preparation
- Surface has to be sound and dry, free from laitance, grease, oil and any other contamination.
- The above can be achieved by wire brushing or grit blasting
Application of Primer
Mix the HARDENER into the BASE component of Dr. Fixit Pidipoxy EP (Primer) thoroughly, using a slow speed drill for atleast to 3 min. to get a
homogenous mix. Apply a thin coat of Dr. Fixit Pidipoxy EP on the prepared surface at 200-300 gms/m2 depending upon the absorption and
roughness of the surface. Recoat over areas where characteristic dry patches are seen on drying. It can be brush or roller applied.
Application of Screed
- First mix thoroughly hardener into the base
- Then add filler slowly and mix with paddle attached to heavy duty, low speed drilling machine to get a homogeneous mix of the screed
- Overlay Dr. Fixit Repair Mortar over the primer when it is tacky. It is best to work in lanes of 2ft to 3 ft width for effective levelling and
trowelling
- Use steel trowel to finish.
- Overcoating can be taken up after 24 hours of application of application of Dr. Fixit Repair Mortar
- Achieve 3 mm thickness over an area marked to 1.5 m , on a levelled surface
Precautions & Limitations
- Material should be used/laid before pot life i.e. 60 mins. at 30oC
- Part mixing of material is not recommended and will not give you desired results. ( To be deleted )
- No dilution of the product is recommended.
- When being applied on steel surfaces, they should be sand or grit blasted, and primed with Dr. Fixit Pidipoxy EP
- Actual quantity of materials to be ascertained before mixing.
- All tools and tackles should be cleaned before the pot life period
- Should be applied with gloves and avoid contact with skin or eyes.
- Any splashes in the eyes have to be immediately washed with plenty of clean water and medical advice should be taken.
|
 Download |
|
