|
Technical Information
| Appearance |
: |
Clear |
| Specific gravity |
: |
0.80 ± 0.02 |
| Coverage |
: |
Approx. 2-4 m2 (on brick wall)
Approx. 3-5 m2 (on plastered surfaces) |
Packing
1 litre, 10 litres & 225 litres
Areas of Application
- Cement painted surfaces, concrete, mortar, clay brick surfaces, etc.
- Natural and artificial stones
- Mangalore tiled roofs
- Corrugated AC sheet roofing, etc.
top
Method of Application
- Surface should be dry and free from all debris, dirt, oil, grease, wax and all other contamination, which could prevent penetration.
- Apply one liberal coat of Dr. Fixit Repellin WR by brushing evenly on the prepared surface. Allow the surface to dry for a minimum of 24 hrs. For best results.
- Dr. Fixit Repellin WR can also be applied with an airless spray (0.07 - 0.1 N/mm2 pressure).
- Before taking up application on a large area, it is advisable to check the performance of the product on a relatively small area.
Precautions & Limitations
- Do not dilute with water or by any other means.
- Close the container lid properly after use
- Before applying over the natural stones like sand stone, slate or Dholpur sampling should be done on a small area to check its suitability.
|
 Download |
|
